产品展示

当前位置: 首页>>新闻动态 >> 「硬质快速门」快速门电机设备要害

「硬质快速门」快速门电机设备要害

作者:硬质快速门伺服电机   发布时间: 2019/8/20 10:15:55


「硬质快速门」快速门电机设备要害



"Hard Fast Gate" Fast Gate Motor Equipment Key Points

 



快速门是现在许多大型企业的常用门和一些特别职业的专用门。



Fast Gate is a common door in many large enterprises and a special specialty for some special professions.

 

硬质快速门电机批发
 




而快速卷帘门能够快速的运转都离不开电机的驱动效果,而电机运用寿数的长短除了和日常保养有关外与其设备也有直接的联络,若是快速卷帘门的电机设备不妥,整个快速卷帘门的运转也将受到很大的影响。



The fast rolling shutter can run fast without the driving effect of the motor. Besides the daily maintenance, the service life of the motor has direct contact with its equipment. If the motor equipment of the fast rolling shutter is not appropriate, the operation of the whole fast rolling shutter will be greatly affected.



下面我们就来简略谈谈快速卷帘门电机的设备留意要害,希望对我们有所协助。



Next, we will briefly talk about the key points of the equipment of the fast rolling shutter motor, hoping to help us.



设备过快速卷帘门的人都知道,快速门电机以及减速电机只能以规定的设备办法设备,并要按照说明要求将电机装配在平整、无振动、耐扭曲变形的底座上,哪还有哪些要害可留意的呢?



Everyone knows that fast shutter motors and deceleration motors can only be equipped according to the prescribed equipment methods, and the motors should be assembled on a flat, non-vibration, distortion-resistant base according to the instructions. What are the key points to pay attention to?



「硬质快速门」快速门电机设备要害



"Hard Fast Gate" Fast Gate Motor Equipment Key Points



在设备快速卷帘门的电机时,先将快速门电机和从动设备对中,避免输出轴负荷超出容许范围,在此过程中要留意容许的径向力和轴向力,千万不要敲击和碰击轴端。然后,运用电机轴动平衡带有半键来平衡套装在轴上的零件。



When the motor of the fast rolling shutter door is equipped, align the motor of the fast shutter and the driven equipment first, so as to avoid the output shaft load exceeding the allowable range. In this process, we should pay attention to the allowable radial and axial forces, and never hit or hit the shaft end. Then, the dynamic balance of the motor shaft with half key is used to balance the parts mounted on the shaft.



当快速卷帘门电机是以笔直的办法来设备时,电机的上方要设有遮盖防雨罩来避免有液体或是异物侵略到快速门电机的内部。



When the fast shutter door motor is equipped in a straight way, it should be covered with a rain shield above the motor to prevent liquid or foreign matter from invading the inside of the fast door motor.



一般来说,冷凝水排放孔大多会用塑料塞来密封,只要在需求的情况下才能够翻开。



Generally speaking, condensate discharge holes are mostly sealed with plastic plugs, which can be opened only when required.



快速卷帘门的设备人员留意提示运用人员,制止将冷凝水排放孔打开,这会使具有较高防护等级的外壳防护无效。



The equipment personnel of the fast rolling shutter door should warn the operators to stop opening the condensate drainage hole, which will make the shell protection with higher protection level ineffective.

 

涡轮硬质快速门电机




此外,假设快速门电机是带有手动设备的制动电机,设备这类电机时,一定要拧上手动开释杆(回弹式手动开释设备)或许拧螺栓(固定手动开释设备),确保快速门电机的运用安全,避免意外安全事故的发作。



In addition, assuming that the fast door motor is a brake motor with manual equipment, when equipped with such motors, it is necessary to screw on the manual release rod (rebound manual release device) or bolt (fixed manual release device) to ensure the safe operation of the fast door motor and avoid accidents.
 

 

 

相关新闻:

『四平堆积门』厂房工业快速门维修 19-12-04
『通化快速门』安装硬质快速门现场应满足什么条件 19-12-04
『乌兰浩特快速门』堆积门的保温防寒效果 19-11-29
『辽阳快速门』防寒堆积门生产厂家 19-11-29
版权所有:沈阳龙盛快速门制造有限公司联系我们:13940183063全国热线:4006080090
公司地址:沈阳于洪区黄海路29号座机:024-31081023百度地图 - 网站地图 -